Except where otherwise noted, content on this site is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International licence.
Proper Printing 2021 by Schone Engineering
Image gallery
3D view
No 3D preview available
Refresh the page if the 3D view does not work
Wall mount filament holder
Suggested Price: €3.00
You can enter any value in the price field to make a donation. Don’t want to donate? Simply enter an amount of 0
Suggested Price: €3.00
Disclaimer: No rights can be derived from the use of the designs or information on this website. Use of these designs is at your own risk at all times. Schone Engineering and Proper printing do not accept liability for any damage resulting from the use of the designs.
Summary
This wall mount filament holder is designed to use as little material as possible. The print takes less than 30 minutes and uses 4 grams of material. It contains filament clips for 1,75 and 2,85mm filament which is able to hold the filament and let it loose if the spool is removed from the holder. The maximum edge thickness of the spool is 7mm and it is designed for 200mm spools but it should hold different diameters just fine. Mounting instructions can be found on the drawing.
Print Settings
Printer: Creality CR-10
Rafts: No
Supports: Doesn’t matter
Resolution: 0.2
Infill: 20%
Filament: PLA
Mounting instructions
- Mount upper fasteners horizontally aligned with a center distance similar to filament reel diameter
- Place filament reel and align both holders
- Mount lower fasteners
Reviews
There are no reviews yet.